Please post anything MG related that doesn't belong in the other model-specific forums.
- Posts: 1
- Joined: Wed Oct 02, 2019 8:09 pm
...long story short, changing the slave cylinder ive managed to drop a one of the bolts into the bell housing ( PLONKER ) through the pushrod hole. MG MIDGET 1500....... i heard it hit the bottom so there must be space in there ? .... thoughts anyone pls, leave it? ... take the whole thing apart ? .... does anyone know any tricks ?
- Posts: 53
- Joined: Wed Jul 05, 2017 11:41 am
Undo the engine to bellousing bolts, loosen the engine and gearbox mounts and gently prise a gap between the engine and gearbox. Make the gap wider at the bottom and put a couple of wedges (e.g handle of a screwriver, half inch thick bit of wood etc) to space the bellousing away from the back of the engine. Use a bit of stiff wire to fish around in the bottom of the bellhousing for the bolt.
Hopefully though you will have successfully sorted this in the time since your post
Return to “MG General Chat”
Who is online
Users browsing this forum: No registered users and 2 guests