Fitting the kit was simple but when refitting the cover I found to my dismay that the cause of the oil leak was the fact that the bottom thread had stripped and I could not get the required torque on it.
The only option appeared to be to fit a helicoil insert, but there is just not enough room to drill/tap and fit the insert.
My query therefore is - does anyone know if it is possible to renew the front engine crank seal block whilst the engine is in the car?
I was hoping that maybe this could be done from underneath by removing the sump.
Any help or suggestions will be much appreciated.
Who is online
Users browsing this forum: No registered users and 1 guest